Today seen the purchase of a couple of gauge holders, a Greddy temp gauge and controller & a Greddy water sensor adaptor. These are very cool gauges with peak recall and settable warning light. Once arrived and installed, they will look after boost pressure and water temp
After getting advice from my mate, Brian, and the chaps at PGA, the car is running again. The CAS needed to be adjusted to get the timing right, once it was the motor was accepting revs as normal. I’ve ordered a nice Greddy oil cap which won’t be here until April sometime, some new wheel […]
I got the engine finished off and running this weekend. Unfortunately I still have the S13 temperature sender in the inlet manifold as a new hole needs to be tapped for the N13 one, something for Bri-Z Fabrication I hope. So I pretty much have no temperature guage as slightly warm reads past ‘H’ on […]
I have finally got around to getting the blog back on air, it only took a year. I will have to get into the routine of updating the site again. Last weekend saw the new UKDM CA18 head assembled and installed into the car along with a full Cometic MLS top end gasket kit. The […]
